Leak Fix Pro
Get Estimate
Repair TipsLocal Guides

Why does my toilet keep running after flushing


A toilet that keeps running after flushing is almost always a worn flapper, a misadjusted fill valve, or a stuck float. Here is how Newnan homeowners diagnose and fix it.

LLeak Fix Pro ·November 2026 ·9 min read
Handyman standing on a ladder with tool belt, repairing outdoors with visible tools.

Your toilet keeps running after flushing because the flapper is not sealing against the flush valve seat, or the fill valve is not shutting off when the tank reaches its set level. Those two failures account for roughly 9 out of 10 running toilets we see in Newnan, and both are cheap to fix once you know which one is failing. If you have been listening to that hiss for more than a day, you are also pouring water - and money - down the drain every hour. This post walks through the real causes, how to tell them apart in five minutes, what a fix costs in 2026, and when a running toilet is actually a symptom of something bigger under your slab.

The short answer: why your toilet keeps running after flushing

Why does my toilet keep running after flushing in Newnan GA comes down to one of five mechanical failures inside the tank: a warped flapper, a corroded flush valve seat, a fill valve that will not close, a float set too high, or a refill tube shoved down the overflow pipe. None of these are mysterious. Each one has a distinct sound and a distinct fix.

A running toilet is a plumbing problem that lets water continuously escape from the tank into the bowl, which then triggers the fill valve to keep replacing it. That cycle repeats until you either fix the part or shut the water off at the wall. Newnan's water is moderately hard - we routinely see calcium scale on flappers and valve seats in homes that are only four or five years old, which is faster than most homeowners expect.

If you have already replaced the flapper twice and the toilet still runs, stop buying parts. Something else is going on, and we cover that scenario below.

The five parts that cause a running toilet

Every running toilet in Newnan traces back to one of five components inside the tank. Here is what each one does, how it fails, and how to recognize it.

1. The flapper

The flapper is the rubber seal at the bottom of the tank that lifts when you press the handle and drops back down to hold water. It is the number one culprit. Rubber hardens, warps, and mineral-stains over time, and once it stops sitting flat on the flush valve seat, water trickles past it constantly.

Signs: a faint hiss that never stops, or the toilet re-fills on its own a few minutes after you walk away. Flappers cost $6 to $15 at any Newnan hardware store and take about five minutes to swap.

2. The flush valve seat

The seat is the plastic or brass ring the flapper rests against. If it is pitted, scaled, or cracked, a brand-new flapper will not seal against it. This is the most common reason a toilet keeps running after a flapper replacement.

Signs: you replaced the flapper and the running stopped for a week, then came back. A seat repair kit runs $10 to $20, or you replace the whole flush valve assembly for $25 to $45.

3. The fill valve

The fill valve (sometimes called the ballcock) refills the tank after a flush and shuts off when the water hits the set level. Diaphragms inside wear out, and sediment from the supply line can jam the seal open.

Signs: water keeps running into the tank even when the tank is full, or you hear a high-pitched whine. A replacement fill valve is $12 to $25 and takes 15 to 20 minutes.

4. The float

The float tells the fill valve when to stop. If it is set too high, water spills into the overflow tube continuously. If it is cracked and taking on water, it sinks and never triggers the shutoff.

Signs: water visibly draining into the overflow tube in the center of the tank. Adjust the float screw a half-turn at a time until the water line sits about 1 inch below the top of the overflow tube.

5. The refill tube

The refill tube is the small flexible hose that runs from the fill valve into the overflow pipe. If it is pushed too far down into the overflow, it siphons water out of the tank continuously.

Signs: the toilet runs quietly and constantly, and the tank level looks correct. Pull the tube up so it sits above the water line, clipped to the top of the overflow pipe.

How much water is a running toilet actually wasting in Newnan?

A running toilet in Newnan wastes between 200 and 4,000 gallons per day depending on how badly the flapper is leaking. That is not a scare number - it is what the math shows when you time how long it takes the tank to refill on its own.

Here is how to estimate yours. Shut the water off at the wall valve, mark the tank level with a pencil, wait exactly one hour, and measure how far the level dropped. A 1-inch drop in a standard 1.6-gallon-per-flush tank works out to roughly 30 to 40 gallons per day. A steady trickle that refills the tank every 10 minutes is closer to 700 gallons per day.

Newnan Utilities bills water in 1,000-gallon increments, and rates have climbed steadily. A silent flapper leak that runs for a full month can add $60 to $150 to a residential bill. A badly failed fill valve can push that past $300. If your bill spiked and you cannot find the source, a running toilet is the first thing to rule out - and if it is not the toilet, you may be looking at a hidden leak. Our team handles slab leak repair newnan GA for exactly that scenario, and we can tell you within an hour whether the loss is above or below the slab.

How to diagnose a running toilet in five minutes

Diagnosing a running toilet in Newnan takes five minutes and no tools. Work through these steps in order and you will know exactly which part is failing before you spend a dollar.

  1. Lift the tank lid and look. If the water level is above the overflow tube, the float is set too high. If it is below the overflow tube and the toilet is still running, the flapper or fill valve is the problem.
  2. Add a few drops of food coloring to the tank. Do not flush. Wait 10 minutes. If color appears in the bowl, the flapper is leaking past the seat.
  3. Shut off the wall valve and listen. If the hissing stops, the problem is inside the tank. If it continues, you have a supply-side issue.
  4. Check the refill tube. If it is jammed down inside the overflow pipe, that alone can cause a constant run.
  5. Jiggle the handle. If the running stops, the flapper is hanging up on the chain or the handle arm is too tight.

If the food coloring test shows clear water in the bowl but the tank still refills on its own, the fill valve is the culprit. If color shows up in the bowl, it is the flapper or the seat.

How to fix a running toilet in Newnan GA

How to fix a running toilet in Newnan GA depends entirely on which part failed. Here are the four fixes that cover almost every case, in order of how often we perform them.

Replace the flapper

Shut off the wall valve, flush to empty the tank, unhook the old flapper from the overflow tube, and clip on the new one. Match the flapper to your toilet brand - a generic flapper on a TOTO or Kohler will not seal correctly. Cost: $6 to $15. Time: 5 minutes.

Clean or replace the flush valve seat

If the seat is scaled, a light scrub with a nylon pad and white vinegar will sometimes restore the seal. If it is pitted or cracked, replace the entire flush valve assembly. Cost: $25 to $45. Time: 30 to 45 minutes.

Replace the fill valve

Drain the tank, disconnect the supply line, unscrew the old valve from under the tank, and install the new one. Set the water level 1 inch below the overflow tube. Cost: $12 to $25. Time: 20 minutes.

Adjust the float and refill tube

Turn the adjustment screw clockwise to lower the water level, and pull the refill tube up so it sits above the water line. Cost: $0. Time: 2 minutes.

If you have replaced the flapper and the fill valve and the toilet still runs, the problem is the flush valve seat or a cracked overflow tube. At that point, replacing the entire toilet is often cheaper than chasing parts - and if the toilet is more than 20 years old, a modern 1.28-gallon model will pay for itself in water savings within a few years. We handle toilet leak repair newnan GA for homeowners who would rather not spend a Saturday on it.

Common mistakes Newnan homeowners make with a running toilet

The most common mistake Newnan homeowners make with a running toilet is replacing the flapper without checking the seat underneath it. A new flapper on a pitted seat will leak again within weeks.

Other mistakes we see regularly:

  • Buying a universal flapper. Universal flappers fit universal toilets. If yours is a specific brand, buy the brand-specific part.
  • Over-tightening the fill valve. Hand-tight plus a quarter turn is enough. Over-tightening cracks the tank and turns a $20 fix into a $400 toilet replacement.
  • Ignoring the wall valve. If the shutoff valve under the toilet will not close, you cannot work on the tank. That valve is worth replacing while you are in there.
  • Assuming it is just the toilet. A toilet that runs is one thing. A toilet that runs and a water bill that jumped 40 percent is two things. The second one is often a slab leak, and it gets worse every week you wait.
  • Using bleach tablets in the tank. Drop-in chlorine tablets destroy flappers and valve seals in under a year. If you use them, expect to replace the flapper annually.

If you have ruled out the toilet and your bill is still climbing, the next step is a proper leak search. We use slab leak detection newnan GA equipment that pinpoints the break without tearing up your floors, and we can usually tell you the same day whether the loss is under the slab or somewhere else on the property.

When to call a professional for a running toilet

Call a professional when you have replaced the flapper and the fill valve and the toilet still runs, when the tank itself is cracked, or when the shutoff valve under the toilet will not close. Those three situations are where DIY stops being cheaper than a service call.

You should also call if the running toilet is paired with any of these:

  • Water stains on the ceiling below the bathroom
  • A water bill that jumped more than 20 percent with no change in usage
  • A warm spot on the floor near the toilet
  • The sound of running water when every fixture in the house is off
  • Soft or spongy flooring around the base of the toilet

Any of those point to a leak that is not in the tank. A toilet that runs because of a failed flapper is a $150 repair. A toilet that appears to run because of a slab leak under the bathroom floor is a different job entirely, and the sooner it is found, the less flooring and concrete you replace. Our team at Leak Fix Pro handles both. We find the leak, fix it, and test the line before we leave.

If you are in one of the older neighborhoods off Jackson Street or near the Coweta County courthouse square, we also see cast iron drain lines that have been in the ground since the 1960s. A running toilet there is sometimes the first sign that the drain line under the slab has finally given up. We handle cast iron pipe replacement newnan for those homes, and we can tell you during the same visit whether you are looking at a $200 toilet repair or a larger under-slab job.

Frequently Asked Questions

Why does my toilet keep running after flushing in Newnan GA?

In Newnan, the cause is almost always a worn flapper or a scaled flush valve seat, because our moderately hard water accelerates mineral buildup on rubber seals. A failed fill valve or a float set too high accounts for most of the rest. The food coloring test tells you which one in 10 minutes.

What causes a toilet to keep running in Newnan?

Five parts cause it: the flapper, the flush valve seat, the fill valve, the float, and the refill tube. Newnan's water chemistry shortens flapper life to roughly 3 to 5 years in most homes, compared to 5 to 7 years in softer-water regions.

How do I fix a running toilet in Georgia?

Shut off the wall valve, drain the tank, and replace the flapper first - that fixes about 70 percent of cases for under $15. If it still runs, replace the fill valve. If it still runs after both, the flush valve seat is the problem and the assembly needs replacing.

Does a running toilet increase my water bill in Newnan GA?

Yes. A silent flapper leak wastes 200 to 700 gallons per day, which adds roughly $60 to $150 to a monthly Newnan Utilities bill. A fully failed fill valve can push the increase past $300. Fixing a $12 flapper usually pays for itself in the first billing cycle.

Who do I call for a running toilet in Newnan?

Call a licensed plumber if you have replaced the flapper and fill valve and the toilet still runs, or if you see water damage, a spongy floor, or a bill spike that does not match the toilet's leak rate. Leak Fix Pro handles both toilet repairs and the under-slab leaks that sometimes cause them.

Get help with slab leak repair in newnan

If you have ruled out the flapper and the fill valve and your water bill is still climbing, the leak is probably not in the toilet - it is under the floor. We find it, fix it, and restore the concrete, usually within a day or two.

Call Leak Fix Pro at (470) 587-8457 and we will schedule a leak inspection at your Newnan home.

Tagged with

#running toilet#toilet repair#water bill#newnan ga#plumbing

Common Questions

Why does my toilet keep running after flushing in Newnan GA?
In Newnan, the cause is almost always a worn flapper or a scaled flush valve seat, because our moderately hard water accelerates mineral buildup on rubber seals. A failed fill valve or a float set too high accounts for most of the rest. The food coloring test tells you which one in 10 minutes.
What causes a toilet to keep running in Newnan?
Five parts cause it: the flapper, the flush valve seat, the fill valve, the float, and the refill tube. Newnan's water chemistry shortens flapper life to roughly 3 to 5 years in most homes, compared to 5 to 7 years in softer-water regions.
How do I fix a running toilet in Georgia?
Shut off the wall valve, drain the tank, and replace the flapper first - that fixes about 70 percent of cases for under $15. If it still runs, replace the fill valve. If it still runs after both, the flush valve seat is the problem and the assembly needs replacing.
Does a running toilet increase my water bill in Newnan GA?
Yes. A silent flapper leak wastes 200 to 700 gallons per day, which adds roughly $60 to $150 to a monthly Newnan Utilities bill. A fully failed fill valve can push the increase past $300. Fixing a $12 flapper usually pays for itself in the first billing cycle.
Who do I call for a running toilet in Newnan?
Call a licensed plumber if you have replaced the flapper and fill valve and the toilet still runs, or if you see water damage, a spongy floor, or a bill spike that does not match the toilet's leak rate. Leak Fix Pro handles both toilet repairs and the under-slab leaks that sometimes cause them.

Need slab leak repair in Newnan? We find it, fix it, and restore the floor.

If your toilet has been ruled out and your water bill is still climbing, the leak is probably under the slab. Call Leak Fix Pro and we will schedule an inspection at your Newnan home.

Call (470) 587-8457 Send a Message
Call (470) 587-8457 Get Quote
Call Quote